Notes: Latest version of the mini synth that began life as a DIY kit. Simple analogue architecture which offers a good introduction to subtractive synthesis and sound design. … Read more
This project is a reprise of the Sound Lab Mini-Synth with the addition of a Sample and Hold and several circuit and component value changes to improve performance. Even if you already have a Sound Lab, this is thoroughly recommended as a completely new project.New design and a new MIDI INTERFACE onboard.
You can play your SLMS+ with a midi keyboard or midi controller.
Type: Analog Synthesis: Subtractive
Oscillators: 2 Waveforms: Pulse, Pulse Variable, Saw Down, Square Osc Modulation: Envelope, Input, Knob, LFO, Sync Hard
Envelope: 1 Evelope
Paramerters: Attack, Decay, Looping
Filters: 1 Types: 12dB Slope (2-pole), Low Pass, Resonance Filter Modulation: Envelope, Knob, LFO, S&H
Lfo: 1 LFO Parameters: Saw Up, Saw Down, Square, Triangle
Sample & Hold Addon: variable sample rate - output voltage glide - switch to select source to be modulate
Midi cannel: 1 (not exchangeable) Midi port: MIDI IN, MIDI THRU Control change: pitch bend, modulation , portamento (CC 5) 1V/Oct: 5 octaves
IMPORTANT: POWER ON SOUNDLAB WHEN YOUR MIDI SEQUENCER IS IN STOP MODE! MICROCONTROLLER CAN GENERATE MIDI SIGNAL ERROR IF YOUR SEQUENCER IS IN PLAY MODE.
Polyphony: 1 Timbrality
1 Tuning: Standard Modes: Mono
Desktop Controls: Knobs, Switches, Buttons Display Type: LED Dimension: 27 x 16 x 7 (cm) Material: Plexiglass Front panel: Aluminum (1mm thick)
Connections: Audio Output Connections: 1/4" Phone Jack, Mono Out
Power: 9V power supply 300 mA (euro) Audio Output Count: 1 Control voltage: 2 - 1V/Oct (1/4" Phone Jack/3,5 mini jack) Gate in: 1 (1/4" Phone Jack/3,5 mini jack) IMPORTANT NOTE: TO USE GATE/MIDI