New releases this week: All genres

Notes: The One to Four Splitter allows the user to take one input and send it through four buffered outputs for unlimited creative potential. Use it to run out to four amps to play in quadraphonic sound and blow people's minds. Send a clean signal to your DAW and another through your normal signal chain to have a clean back up while recording. Run 2 parallel stereo signal paths! Use the One to Four splitter together with the Four to One Mixer and create wild parallel signal chains! Use the Buffer/Splitter and run 2 x One to Four Splitters to have 8 parallel paths!

This device features a unity gain buffer on each output for maximum punch and clarity. These buffered outputs have a flat frequency response with a high 1 Mohm input impedance and a low 100 ohm output impedance. This means that your signal won't lose any quality and will sound just like you intended. Even long cable runs will be no match for the One to Four Splitter.

Dimensions

4.75 x 2.5 x 1.5 in. (120 × 63 × 38 mm)

Current Draw

15 mA

Input Impedance

1 MO

Output Impedance

100 O

Power

This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. EQD always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!