Field recorder meets interface in this clever offering from IK's iRig range. Essentially a 4-in / 2-out audio and MIDI interface with built-in mics, the Quattro is portable, versatile and high quality.

Supplier's Notes:
Pro recording and performing, in the palm of your hand

iRig Pro Quattro I / O is a professional-quality 4 in / 2 out portable audio and MIDI interface packed with everything needed for field recording and content creation, for serious sound and flexibility - anywhere.

Small enough to fit in the palm of your hand, the iRig Pro Quattro I / O still packs in four high-quality, low-noise mic preamps; instrument, RCA and TRS inputs; plus XLR balanced, 3.5mm stereo and headphone outputs - and full MIDI I / O!

iRig Pro Quattro I / O works right out of the box with iPhone, iPad, Android, Mac and PC, but can also serve as a stand-alone mic preamp or line mixer, with a built-in limiter and direct monitoring so you're always guaranteed the perfect take.

Packed with a swiss-army-knife's worth of tools, iRig Pro Quattro I / O ensures you're ready for anything, anywhere.

As a mobile interface

Connected to a computer or mobile device, the iRig Pro Quattro I / O will work as a high-quality, multi-channel audio and MIDI interface with a full array of inputs and outputs so you'll always be prepared for any recording or need. Fully MFi-certified, no adaptors are required for iPhone or iPad for reliable field performance on any device.

As a broadcast / podcast interface

Enable STEREO mode and iRig Pro Quattro I / O mixes all sources down to stereo for streaming or recording. Monitoring is easy thanks to a dedicated headphone output with independent volume control and direct monitoring. Or use MONO mode for streaming to social media; Loopback lets you duet your favourite videos easily.

As a field recording interface

With an onboard microphone and optional stereo mic capsules, iRig Pro Quattro I / O turns your iPhone, iPad, Android device into a full-featured, professional field recorder.

As a stand-alone mixer

iRig Pro Quattro I / O also works as a preamp and mixer: just power it via battery, USB or DC IN and use the full set of inputs / outputs to capture and mix multiple sources to your DSLR camera with professional quality.

Always perfect recordings with the safety backup channels

In STEREO and MONO mode, inputs 3 and 4 can be used as safety channels: recording the same signal as input 1 and 2 but reduced by 12dB as a backup in case the sound source unexpectedly overloads the main channels.

Audio quality without compromise... wherever you are

Up to 24-bit, 96 kHz sample rate Ultra-low-noise mic preamps with full +48v phantom power Professional-quality, transparent A / D and D / A conversion Built-in limiter, for input 1-2, to protect against clipping Multitrack, stereo or mono internal mixdown.

Specifications

Microphone Input
Microphone Input: balanced female 3-pin, XLR. Pin 2: hot / Pin 3: cold / Pin 1: ground
Microphone Input Level: from 6 mVpp to 1.4 Vpp
Microphone Input Impedance: 3.2 kOhms
Gain Range: 40 dB
Phantom Power: +48V i 4V
Frequency Response: 20 Hz - 20 kHz + / -1.5dB
Input Noise: -103 dB(A), -97 dB RMS

Instrument Input
Instrument Input: unbalanced, Hi-Z, TS 1 / 4" Jack, Tip: signal / Shield: ground
Instrument Input Level: from 30 mVpp to 6.9 Vpp
Instrument Input Impedance: 1 MOhms
Gain Range: 27 dB
Frequency Response: 20 Hz - 20 kHz + / -1.5dB
Input Noise: -103 dB(A), -97 dB RMS
Stereo Headphone Output
Connector: 1 / 8" TRS Jack. Tip: right / Ring: left / Shield: ground
Headphone Level Control numbered thumbwheel
Headphone Level Power 100mW into 50 Ohms

Stereo Headphone Output
Connector: 1 / 8" TRS Jack. Tip: right / Ring: left / Shield: ground
Headphone Level Power 100mW into 50 Ohms

MIDI Input / Output
Connector: 2x2.5mm TS Jack
Other Input / Output
DC barrel: 1x DC barrel. For power and device charging.
Device Connector: mini-DIN

Common
Conversion: 24-bit A / D, 24-bit D / A
Sampling Rate: 44.1 kHz, 48 kHz, 88.2 kHz and 96 kHz

Power:
- USB bus powered when used with a computer
- Battery powered (2xAA included) when used with an iOS device
- DC power supply (not included, iRig PSU 3A sold separately)*

Package includes
iRig Pro I / O universal Audio-MIDI interface
Lightning to Mini-DIN connection cable with charging features (60cm / 23.62")
USB-A to Mini-DIN connection cable (60cm / 23.62")
USB-C to Mini-DIN connection cable (60cm / 23.62")
2.5mm TRS male to MIDI female adapter (10cm / 3.9")
2 x 1.5V AA Battery
Velcro strip

Dimensions
Size: 43mm / 1.69" x 127mm / 5" x 37mm / 1.46"
Weight: 120g / 4.23oz (batteries excluded)